New England Mini V x 300ft. Spool

(No reviews yet) Write a Review
6.00 LBS
10.00 (in)
10.00 (in)
10.00 (in)
Current Stock:

Product Description:
Mini V is constructed of a range of small diameter vectran cored lines. It ranges in size from 1.8mm - 4mm and comes in a variety of colors. Mini V is ideally suited for dinghy control lines and almost any application where you're looking for high strength, low stretch, excellent knotability, and holding power. New England Ropes in collaboration with US Olympic Sailors, spearheaded the development of this product.


  • Low Stretch
  • Lightweight
  • Easily fed through small leads
  • Wide range of colors


  • Control lines
  • Sheets
  • Halyards

Colors Available:

  • Black
  • Blue
  • Red
  • Yellow

Lengths Available:

 3/32" (2mm)  0.2  3.9  270  120
 1/8" (3mm)  0.4  5.9  930  413
 5/32 (4mm)  0.9  13.3  1,440  640

Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Polyester has good resistance to most chemicals except 95% sulfuric acid and strong alkalines at boil. HMPE has good resistance to most minerals, organics, acids, and weak alkalines. HMPE also has excellent resistance to bleaches and other oxidizing agen

Polyester melts at 480°F with progressive strength loss above 300°F.

Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Recommended sheave diameter to rope diameter is 8:1.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
Core-to-Core Splice (note 1/16" is not spliceable)  

Connect with us on Instagram @cbknot!