Loading... Please wait...

Our Newsletter

New England WIre Core Fliplines

  • New England Wire core Flip Lines
  • New England Wire core Flip Lines
Call 509-291-3024 or email cbknot@cbknot.com for pricing.
15.00 LBS

Product Description

Product Description:
Manufactured from our trademark Hi-Vee cover with plied strands for greater abraison resistance and sure grip of adjusters. Size and construction permit use of most ascenders/adjustors. Unique eye termination helps alleviate pivot point stress for increased service life.


  • Tight, snag-free construction
  • Lightweight for improved performance and easier use
  • Available in 2 styles: ~CE-approved eye and thimble in both ends ~CE-approved Eye and thimble in one end and locking snap on the opposite end.
  • Also available with Swivel Snaps 


  • Flipline

 Colors Available:

  • Orange and White

 Lengths Available:

  • 8'
  • 10'
  • 12'
  • 14'
  • 16'
  • 2M
 1/2"  -  -  -  -

Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Polyester has good resistance to most chemicals, except 95% sulfuric acid and strong alkalines at boil.

Polyester melts at 480°F with progressive strength loss above 300°F.

Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.


Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
Not Applicable

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the New England WIre Core Fliplines to your wish list.

You Recently Viewed...