Teufelberger (New England) Polyester Accessory Cord Spool

Teufelberger (New England Ropes)

For availability and pricing call 509-291-3024 or email cbknot@cbknot.com

(No reviews yet)
2.00 LBS
8.00 (in)
8.00 (in)
8.00 (in)
Current Stock:

Product Description:
Our Polyester Accessory Cord offers the best of both worlds. Polyester resists water, has less stretch, has super vibrant colors, and has greater UV resistance. Polyester is also more durable than nylon and its lower stretch offers more abrasion resistance. The Polyester Accessory Cord carries UIAA 102 and EN 564 certification. 


  • Water Resistant
  • UV Resistant
  • Low Stretch


  • Tie down rope
  • Throw Line

Colors Available:

  • Blue-Yellow
  • Red-Black
  • Black-Orange
  • Orange-Black
  • Yellow-Blue
  • Yellow-Black
  • Blue-Red
  • Red-Blue
  • Blue-Green
  • Green-Blue
 3mm  -  -  -  -
 4mm  0.8  12.3  890  404
 5mm  1.3  18.9  1,180  535
 6mm  1.8  26.8  1,850  839
 7mm  2.3  34.2  2,550  1,157

Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

polyester has good resistance to most chemicals, except 95% sulfuric acid and strong alkalines at boil.

Polyester melts at 480°F with progressive strength loss above 300°F.

Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.


Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
Not Spliceable